where n is the unique node id and /dev/ttyUSB0/ is the specific port that the mote is attached to.

Alternatively the mote can be programmed using the following command:

make telosb install,n bsl,ref M4A6J3PH

where M4A6J3PH is the unique id of the mote. To get the id, use the motelist command.

In virtualbox, it is possible to define a shared folder that is accessible by both the host OS and the guest OS.
Given that guest OS is Linux, to access this shared folder run the following commands:
1. Create a mount point:
mkdir shareddir

2. Mount:
mount -t vboxsf share shareddir
where share is the shared folder

tar xvfz quagga-0.99.9.tar.gz

2. Download quagga-0.99.9.ospfv3-manetmdr-gtnets.patch from http://hipserver.mct.phantomworks.org/ietf/ospf/ to the quagga folder in 1. Run the following command:

patch -p1 < quagga-0.99.9.ospfv3-manetmdr-gtnets.patch

3. Run the following command in the quagga folder:

./configure

4. Comment out #define VERSION “0.99.9″ in config.h

5. Goto SRC/ under GTNetS directory and create a link to the quagga directory as follows:

ln -s  /home/user/quagga-0.99.9/ quagga

6. Goto GTNets and run the following command:

make depend

make debug

The installation is now completed

http://www.ece.gatech.edu/research/labs/MANIACS/GTNetS/downloads.html

2. tar xvf GTNetS-Oct-10-08.tar.gz

3. GTNetS requires that the following :

• g++   (g++32 does not work)
• Qt3 (see FAQ on installations on Ubuntu)

4. g++ is usually preinstalled, so we need to install Qt3. This is an easy task using the Synaptics Package Manager under System -> Administration.

On Ubuntu you may need to install the following packages at the minimum:

5. After having installed Qt3, we can now install GTNetS running the following command sequentially:

• make depend
• make debug

ulimit -c 100000

2. add “-g” to the CFLAGS in the Makefile so that debugging is enabled. Run make clean and then make.

3.When a segmentation fault occurs, type: “gdb -c core“, then in gdb tell it that you want to load symbols from the ns executable with “file ns“,and then you can inspect the stack (“bt“), select a stack frame (“select 0“) and inspect the values of variables in that stack frame.

Ref. http://article.gmane.org/gmane.network.simulator.isi/2766/match=segmentation

Check also the cheat sheet for dpkg command:
http://www.cyberciti.biz/howto/question/linux/dpkg-cheat-sheet.php

To display general information about a single package:
apt-cache showpkg eclipse

Find all files that begins with “wtrace.tr.” and ends with either one or two digits, e.g. “wtrace.tr.1″ or “wtrace.tr.10″ in current folder and recursive folders:
find -regex .*/wtrace.tr.[0-9]+

If we want to find the files as above and at the same time want to gzip all the files found, we may combine the previous command as follows:
find -regex .*/wtrace.tr.[0-9]+ -exec gzip {} \;